I purchased a throttle body rebuild kit from Rockauto that included everything I needed for my '92 Tracker 8v.

 

I'm guessing I'm suppose to use the one pictured below? seemed much thinner than the round one currently installed...

 

your old one evaporate>? even the stuck on parts are clear to see?
btw A/T and M/T are different.

my hard to by parts page
has that (see my annotted link there. IDs each part

hard to find parts, some are very hard !

 

I thought I mentioned I have an auto transmission...

The old gasket is still on the top of the throttle body. since it's probably 20+ years old and brittle, i'd like to replace it.

the throttle body rebuild kit (annotated picture from your site included) does not show it or include the gasket/seal I originally asked about. (I have the kit in hand).

I guess you could have noticed that the gasket I'm looking for is mentioned nowhere in your annotated parts list for the gasket set (shown below).

Maybe my eyes are going bad and I just can't see it?

 

I'm also looking for the gasket/seal that goes between the throttle body and the intake runner (sits around the fuel injector). picture is attached. Can't seem to find it anywhere...

im sorry i can not decode that.... not a problem the physical world is best done in graphics....
the TB base gaskets are in that kit.
so you must mean the injector 0-rings..... below has them. and are hard to find.



between tb and intake
no , ok
injector seals , on is viton fuel side other is vacuum cushion seal.
same page.

hard to find parts, some are very hard !

hard to find parts, some are very hard !

and takes you here
injector seal kits

i show the 3 steps so you can see, all the other hard finds.

 

those are injector o-rings, you never said inside the TB.?

injector seal kits
very hard to find,
suzuki dont sell them not in 5 years.

GB reman inc ,did
pn 8-011
ive tried to find them
but my injector service cleaned mine for $19 and added 2 seals.

there are 3 companies that stopped. making the kit
GP was the last.
i begged Rockauto to stock them
SEEMS THEY STILL, amazing....

RockAuto Parts Catalog


oriellys
shows BWD 27478
says it fits. so does BWD ECAT.

 

below is a picture of the gasket/seal (in green) I'm looking for.

unmodified version is in first post. (apologies to anyone who's color blind)

 

NEW or rebuilt?, (2 vastly different answers)

water pump. (as you know there are many parts in the slot)
china (made by Som Ting Wong (junk) any thing with china bearing is junk.
(bearings with same name.)
Japan made (prime)
beck
acdelco
gates all these are good. cept , WONG
look on rockauto.com see the cheap $17 one , avoid it like the plague.


RockAuto Parts Catalog


in my local store
they drop rebuilts on the counter
its sand blasted so bad, (looked like grade 10 sand (from the moon)
and destroyed the thread in the mounts. (tbelt idler)
and had chain crap bearings (no name)
buy new.

 

my god. that just a air tube gasket, make one.?
rock dont have it and never seen one ever ask for one, its so simple.
if you have the old one take it to a auto store and ask for a match up.
not on a week end they be too busy,
some will make the attempt.
did you look in the Felpro ecat? oops they dont make it.... i always buy felpro first...
ok now suzuki
13855-61a00
$2.54
Suzuki Parts - Suzuki Parts | OEM Suzuki Parts | Genuine Suzuki Parts