Hi,
Last week, I successfully set up a Ford/Mazda VCM 2 scan tool with the SDT II software, and I wanted to share the process with all of you.
Firstly, I purchased this specific scan tool:
To make it work with the SDT II software, follow these steps:
1. Download the required software:
That's it! Your Suzuki Scan Tool clone should now be operational.
If you encounter any issues or need assistance, feel free to leave a message.
Last week, I successfully set up a Ford/Mazda VCM 2 scan tool with the SDT II software, and I wanted to share the process with all of you.
Firstly, I purchased this specific scan tool:
To make it work with the SDT II software, follow these steps:
1. Download the required software:
- SDT II Software:
392.71 MB file on MEGA
mega.nz
- Ford VCM 2 Manager 2.1.119.3 or 2.1.1.5 (other versions may work, but these are confirmed):
33.6 MB file on MEGA
- Step 1: Install SDT II
- Step 2: Install Ford VCM 2 Manager
- Step 3: Navigate to either C:\Program Files (x86)\Bosch\VTX-VCI\ or C:\Program Files\Bosch\VTX-VCI\
- Step 4: Open the "VCI Software (Ford-VCM-II)" folder and copy its contents
- Step 5: Paste the files from the Ford folder into the "VCI Software (6516-Suzuki)" folder
- Ensure the VCM 2 has the correct firmware.
- Step 1: Open the Ford VCM 2 Manager
- Step 2: Remove the black plastic piece from the VCM 2 (on the USB side) to locate the button (below the SD card port).
- Step 3: While pressing the button, insert the USB into the VCM 2. Keep pressing the button until a beep is heard (around 20-30 seconds). This puts the VCM 2 into recovery mode.
- Step 4: If successful, select the VCM 2 in the manager and press the Recover button. This uploads the new firmware onto the VCM 2.
That's it! Your Suzuki Scan Tool clone should now be operational.
If you encounter any issues or need assistance, feel free to leave a message.
