Thanks - will watch it!

 

Hope it is possible for ya,this little Ignis of mine has the best lights I've ever had on any car,zenon and Drl and fog,vv good,
Especially in comparison to my last few honda insights

 

You have Xenon?

 

Yes,,, incorrect Gloucester,
I've LED headlights.
Advertised with dealer as Zenon,my mistake.

 

Garrydhu - I do not understand. Why are you quoting yourself and answering to yourself?

 

Just noticed,I was adding onto an answer to Gloucester

 

Probably my language barrier again. It's post number 7.

 

Watched the video, it doesn't look like a very difficult job. One question - is it a "plug and play" swap or are electrical mods required?

 

Specs may be different in other territories but in Europe:
The DRL feed would need to be swapped from the separate units to the headlamps. There are requirements such as that DRL’s must extinguish with headlamps on. Needs investigating but it may be a simple case of teeing the DRL feed into the”sidelight” feed. At worst you might need a relay. Fog lamp units are available for the DRL apertures If you wanted to fit them.

The main loom will be the same for all Ignis models but it would make connection easier if you sourced the spur leads for the new headlamps.

Suzuki and aftermarket headlamps don’t come with levelling motors so unless using 2nd hand units you‘d need to swap the motors over.

 

It will probably be necessary to mount the car's load sensor between the rear axle and the fuel tank
(In the case when there is manual adjustment of the inclination of the lights).

 

Do you perhaps mean when there is automatic adjustment...........