Suzuki Forums banner

samurai starts but won't run

3K views 8 replies 3 participants last post by  Rhinoman 
#1 ·
just got a 92 samurai, it will start if I put fuel down the tbi.
will only run until fuel runs out.
installed new fuel pump & filter, tried different ecm from a buddy.
anyone have any ideas or suggestions?
 
#2 ·
Here's a thought or two:
1) Check fuel pump relay if you have one
2) Was the ecm from the same type of transmission? Manual ECM different from Automatic ECM...
 
#5 ·
Have you tried pulling codes while cranking? the ECU looks for a feedback signal from the ignition and if it doesn't see it it will cut fueling.
 
#7 ·
Cam sensor codes only show while cranking. Have you got a noid light? you should check the the injector is receiving a signal from the ECU.
 
#9 ·
The camshaft sensor but you have spark so that should be OK. Did you check the codes while cranking? if that still shows OK then its probably a faulty ECU.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top