Suzuki Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
7 Posts
Discussion Starter #1
I just replaced the stock bumpers on my rig with the Rocky Road Outfitter's bumpers. The new rear one does not wrap around the corner of the rig like stock did. It is kind of unsightly with 3"-4" of fender flare missing and the scalloped in lower body. Does anyone make a filler panel for this? If not I guess I will have to bend something up to cover as I don't like the look as it is.
Thanks
Jeff
 

·
Premium Member
Joined
·
1,862 Posts
My first 'aftermarket' rear bumper was not a RRO bumper, but I built it to match the RRO front bumper I was running at the time (they are pretty basic). I had the same issue you mention.
I built my own extensions that held up to some pretty good hits on the rocks.
Before:


After:



The whole bumper build is here:
DIY Rear Bumper
 

·
Registered
Joined
·
7 Posts
Discussion Starter #3
Thanks Bill,
That does look good and give me some ideas. I will post back when I figure out how I am going to tackle this.

Jeff
 
1 - 3 of 3 Posts
Top