Suzuki Forums banner

1 - 2 of 2 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter #1
Hello all,

I recently got my TOY250 carb in the mail and I've started the process of removing the stocker. I know this might seem like a stupid questions but are there any tips on getting to the bolts that mount the carb to the intake? I can't get a wrench or a socket on the ones by the valve cover. Thanks in advance, hope I didn't bite off more than I could chew.

Zach
 

·
Registered
Joined
·
264 Posts
I usually pull the valve cover and do a valve adjust at the same time. Makes it easier to get an open end wrench on the carb nuts and gives me an excuse to go ahead and adjust the tappets.
 
1 - 2 of 2 Posts
Top