Suzuki Forums: Suzuki Forum Site - Reply to Topic
Suzuki Forum Suzuki Forums

» Auto Insurance
» Featured Product
Wheel & Tire Center

Go Back   Suzuki Forums: Suzuki Forum Site > Suzuki Models > Suzuki Jimny, Sierra & Samurai Forum > 11.91 volts out of alt ??
Register Home Forum Active Topics Photo Gallery Garage Search Today's Posts Mark Forums Read Auto EscrowAuto LoansInsurance Advertise

Suzuki-Forums.com is the premier Suzuki All Forum on the internet. Registered Users do not see the above ads.
Thread: 11.91 volts out of alt ?? Reply to Thread
Title:
  
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :
Post Icons
You may choose an icon for your message from the following list:
 

Register Now

In order to be able to post messages on the Suzuki Forums: Suzuki Forum Site forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:
Insurance
Please select your insurance company (Optional)

Log-in


Additional Options
Miscellaneous Options

Topic Review (Newest First)
08-07-2010 04:22 PM
squid the first rule of the charging system is you have to have a good battery. a bad battery can cause all sorts of goofy readings.

to check for restance in wiring , hook volt meter between positive post at battery and battery stud post of alt. . run engine with a load on alt (ie. head light on, blower motor on high, ect.). any reading above 0.2 volts is a bad connection in wiring.
second step is to repeat test except now the volt meter will be between the negative post of battery and the case of the alt. any reading of above 0.2 volts is a bad connection in the ground side.

check the two small wire connector at rear of alt. both wires should show 12 volts with key on.

these alts. also have field terminal on regulator. to test, hook volt meter to system voltage . ground one end of a test lead and the other is inserted in hole in rear of alt and contacts field terminal of regulator. ( the hole in rear of alt is labeled with an F. It is easer if you attach test lead to a small screw driver and then insert that into hole) if voltage raises when regulator is grounded , replace regulator. if voltage remains same replace alt.

Squid
08-07-2010 11:35 AM
Merlin93
Quote:
check the voltage AT the alternator. ... The voltage is regulated by the alternator internally. It should be ... over 14 volts ...
X2
First measure the voltage between the alternator (+) output post and the alternator case, NOT the chassis. If it's over 14V, then go chasing around to find out where the bad connection(s) are that are causing you to lose voltage while charging. If it's not over 14V, then it's likely your alternator is bad. The regulator is an internal part of the alternator, so you replace both together. Many/most alternator places will test yours at no charge.

You should also consider an overnight battery charge until you fix the Zuk's wiring problem. Less-than-12V is not charging the battery properly, and you may need to replace it, if you cannot keep it properly charged (I hope it's not already too late). One other possibility is that you have a shorted cell in the battery. Make sure your battery is good before going much further.
08-06-2010 12:37 PM
Baratacus check the voltage AT the alternator. If there is a short anywhere between the alternator and the battery, or if your battery is toasted, it will affect any reading you take at the battery or after the battery. The voltage is regulated by the alternator internally. It should be putting out over 14 volts if it's charging the battery.
08-05-2010 10:24 PM
arlo
11.91 volts out of alt ??

Hey Guys

My alt is putting out 11.91 volts even at hi revs...with all lights and H fan.
Changed out alt with buddies spare...also puts out 11.92 volts.
These alts both have internal regulator tag on them.
Does my ECU control the output ?
This reading is at battery posts and also live wire in cab.
Can there be 2 alts with the same low output ?
Could this be why my yellow top Optima died ?

Still worried about eliminating my ECU...can't find name on donor carb.
Giving that idea a rest for now.

arlo

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Powered by vBadvanced CMPS v3.2.3

All times are GMT -5. The time now is 10:11 AM.



Powered by vBulletin® Copyright ©2000 - 2019, Jelsoft Enterprises Ltd.
Search Engine Optimization by vBSEO 3.6.1
Garage Plus vBulletin Plugins by Drive Thru Online, Inc.
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2019 DragonByte Technologies Ltd.