Cruise control install on 2008 Suzuki Forenza
I bought a Rostra 250-9000 and installed it. I am getting power to the cruise control unit mounted on the colum but it is not locking in the speed.
I ran through the troubleshooting steps listed in the manual and every thing checks out except for the volt readings when testing the wite wire wich runs from the cruise control harness to the ECM module. I am getting 12 volts on that wire.
I have called thier support line and theyt are telling me I do not have the wire in port 45 as outlined in the instructions.
When I pulled off the ECM plug I saw a 48 on the left hand side. So I counted back and placed the wire in the 4th slot from the left.
Can anyone lend a hand on this ?
I am attaching a pic but not sure it helps due to the quality.