Thanks guys. It took almost 4 months before I put my hands on it.
Quote:
Originally Posted by ammx_i
Wow good work, but I have some questions.
1.- Do you have to make a hole where the ballast goes? Or is already made?
2.-The lid goes after the light comes into the set?
3.-the leveling headlights motor works on your vehicle?
4..- How much is the cost of that set??
Thanks for your answer
|
1. No. The EDM (European) headlights go with the centre hole already made. Before I was sealed it with the scoutch tape, thats a reason why the hole is not clean.
2. Yes. Everything is watertight now. Also it is quite easy to replace the bulb if it will burn out.
3. No, I didnt buy them and didnt installed. There are few reasons why I didnt do that. First, it costs a little bit high if you take a whole set including harness and second, the sensor goes under rear suspension and for me it is quite tough to do it, so I just aimed lights properly at the dealer and thats it.
4. In total I spend $2.500 more less and 3 months waiting time.
Headlights I bought in Europe, HID ballast and hardware came in from Japan because they are less expensive over there, also I didnt want to have RHD (Japanse) headlights.
Next step is installation my tireless kit.
Bumper is already painted and polished, and I gonna pick it up tomorrow and then will need to install the door shell and paint it. Thinking I`d be done till the end of July, because my body shop is quite booked right now, then - show time
FYI: the other OEM HID ballast and ignitors I have dont have rubber seals, so you will need to order it. They cost not so expensive, however you might live with out them.
