you cant
its designed so thieves cant, so it follows......
actually they smash a large screw driver in the slot with a hammer.
i watched a pro lock smith try to get the rear pins out without removing the whole thing. He was good, but not that good. ( and 45min, wasted to no gain.) and $$
here is his steps.
make a dent beside pin.
then with special lock smith needle nose pliers, try to pull pins.
actually pulling the switch is 10 min work once wheel is off.
it is not hard at all.
but you need a wheel puller.
flat bar, 2 holes make, 2 bolts, off.
if you think this is hard, try keyless, entry. OMG !
Last edited by jtgh : 06-27-2009 at 11:08 AM.
|
