motor
man. tranny is 5th gear is 1:1 and OD is 1:0.86 in 5th ( diff od ratios on 2wd !)
xfr case is 1:1 , in 2H and 4H, and
1.81:1 4L
so in 4th gear, 2H, the engine spins 1 rev , and same at rear axle pinion.
keep that in mind and all else makes sense. see?
3000 rpm in 4th above is 3000 rpm at rear axle pinion and 5.12 times lower at wheel.
knowing THAT you can calc. distance traveled if you know circumference of tire. Pi x D. = Cir.
distance a second, is found, then times 60 , is distance a minute. ( one must work out miles over inches too)
one can buy 4.24:1 transfer case gears .
the wiki and ever good 4wd web site has gear modelers , that show you how to do it or just pump it in and get an answer.
that's correct, 5.12 turns on pinion , spins wheel 1 time. (crawl under put car in neutral
with both wheels jacked up ,and spin it. and count , 1 potato , 2 potato.
-----------------------------axles ----------------------------------------------
axles
89-98 Trackick gear ratios
Years....2 or 4 door...Engine type...Transmission...Axle ratio
89 2 1.3L carb. 5 speed man. 5.625
89-95 2 1.6L TBI 5 speed man. 5.125
89-95 2 1.6L TBI 3 speed auto 4.625
91 4 1.6L TBI 5 speed man. 5.375 4dr. 2door is 5.125
91 4 1.6L TBI 3 speed auto 4.625 2 or 4dr.
91 samurai, 5sp 3.727 (refr)
92-98 4 1.6L MPFI 5 speed man. 5.125
92-98 4 1.6L MPFI 4 speed auto 5.125
94-98 2 1.6L MPFI 5 speed man. 5.125
94-98 2 1.6L MPFI 3 speed auto 4.30
94-98 2 1.6L MPFI 4 speed auto 5.125
96-98 X90 1.6L MPFI auto or man. 4.625
96-98 4 door 1.8l 16V DOHC MPFI manual or auto 5.125
4.30 gears have a 10/43 tooth count
4.625 gears have an 8/37 tooth count
5.125 gears have an 8/41 tooth count
5.375 gears have an 8/43 tooth count
5.625 gears have an 8/45 tooth count
Last edited by jtgh : 06-20-2009 at 08:55 PM.
|
