Passenger side High Beam Not Working
I have a 95 Geo Tracker. The passenger side high beam does not work regardless of what position the light switch is in i.e., on or flashing.
I measured the voltage and while the driver side measures 12V, the passenger side measures .3V when the high beam switch, hand lever is turned on. The lamp harness is fine, because I striped the wire and it measured .3V at the exposed wire.
Any suggestions on where to look? If so, please describe where I might find and other devices on the car to check. I do not have a manual. I cannot pass inspection until I resolve this problem.
On another note. If I cannot locate the problem, is it possible to join the non working high beam into the working high beam? By that I mean, if i were to strip the high beam wires and tied the non working wire into the working wire would that work or blow a fuse. Can both high beams be fed from the same wire?
|
